Box IP Cameras VPort 36-2L Series Moxa vietnam

Feature and Benefits Why Industrial IP Cameras Provide Better Performance

  • Industrial design with -40 to 75°C operating temperature (heater or cooling fan not required)
  • Maximum 1920 x 1080 resolution at 30 FPS
  • Built-in P-IRIS zoom lens with 3x (3 to 9 mm) and 2x (10 to 23 mm) optical zoom
  • Zoom and focus can be controlled remotely over an IP network
  • Four video streams with H.264 and MJPEG 
  • SD card interface for disconnection and event recording 
  • 12/24 VDC, 24 VAC, or PoE redundant power inputs 
  • EN 50121-4, NEMA TS2 compliance  


The VPort 36-2L rugged 1080P (1920 x 1080) box IP camerasare specially designed for mission-critical and extreme weatherenvironments. The cameras have two kinds of built-in P-iris zoom lenses, 3 to 9 mm and 10 to 23 mm. They support remote zoom and focus control via an IP network, providing convenience and simplicity for camera operation, and feature a wide -40 to 75°C operating temperature range (-T models) and industrial-grade EMC (EMI/ Surge Level 3) protection.


The VPort 36-2L cameras are suitable for the kind of industrial and outdoor environments found with oil & gas, rail, and ITS applications. In addition, the VPort 36-2L supports a light sensor and ICR (IR-cut filter removable) for day & night viewing, advanced WDR (wide dynamic range), and DNR (digital noise reduction), allowing the VPort 36-2L to produce good quality images even in extreme sunlight conditions.
Patent Marking

unit: mm (inch)

Sensor 1/3” progressive scan CMOS
Lens 3X: f=3(wide) to 9 (tele) mm, F1.6 to F2.6
• Horizontal angle of view: 30.2° to 87.4°
• Vertical angle of view: 16.4° to 47°
• Diagonal angle of view: 32.4° to 95.7°
2X: f=10 (wide) to 23 (tele) mm, F1.2 to F2.3
• Horizontal angle of view: 11.4° to 26.9°
• Vertical angle of view: 6.3° to 14.4°
• Diagonal angle of view: 13.7° to 31°
Illumination (low light sensitvity) Color: 0.2 Lux @ F1.2
B/W: 0.1 Lux @ F1.2
Day & Night Auto/Color/BW; ICR Control
Synchronization Internal
White Balance ATW/AWB
Electronic Shutter Auto, Fixed (1/30 to 1/25000 sec)
S/N Ratio 50 dB (AGC, OFF; DNR ON)
ICR Control Auto (light sensor control) or DI control
DNR Built-in DNR (digital noise reduction)
WDR On/Off, up to 100 dB
AGC (auto gain control) 2X, 4X, 8X, 16X
Flickerless Control Automatic, 50 Hz,60 Hz modes
Auto Exposure Level ±5
Image Rotation Flip, Mirror, 90°, 270° and 180° rotation
Image Setting Manual tuning with saturation, sharpness, and contrast
Video Compression H.264 (ISO/IEC 14496-10) or MJPEG
Video Output via Ethernet
Video Streams 4, H.264, or MJPEG independent video streams
Video Resolution and FPS (frames per second)
Video Viewing • DynaStream™ support for changing the video frame rate automatically
• CBR Pro™ support for accurate streaming bit rate control
• 3 privacy mask areas provided
• Adjustable image size and quality
• Timestamp and text overlay
• Maximum of 5 simultaneous unicast connections, 50 multicast clients
Audio Inputs 1, 3.5 mm phone jack
Audio Outputs 1, 3.5 mm phone jack
Audio Format Mono, PCM (G.711); AAC
Protocols IPv4/v6,TCP, UDP, HTTP, SMTP, FTP, NTP, DNS, DHCP, TFTP, UPnP, RTP, RTSP, ICMP, IGMPv3, ARP, QoS, SNMPv1/v2c/v3, DDNS, Modbus/TCP, 802.1X, SSH/HTTPS, OPT66/67
Ethernet 1 10/100BaseT(X) Ethernet port, RJ45 connector
Serial Port
PTZ Ports 1, RS-485, terminal block connector
PTZ Driver Pelco D, Pelco P, custom camera
Local Storage
SD Socket Standard SD socket (SDXC, SDHC)
Digital Inputs 1, max. 8 mA,• High: +13 V to +30 V
• Low: -30 V to +3 V
Relay Outputs 1, max. 24 VDC @ 1 A
LED Indicators
STAT Indicates if the system is booted properly or not
Network 10 Mbps or 100 Mbps
Power Power on/off
Power Requirements
Input Voltage 12/24 VDC, 24 VAC or Power-over-Ethernet redundant power design
Input Current 12/24 VDC, min. 0.91/ 0.38 A; 24 VAC, min. 0.8 A; PoE 48 VDC, min. 0.24A
Physical Characteristics
Housing Metal, IP30 protection
Dimensions 200 x 90 x 70 mm ( 7.9 x 3.5 x 2.8 in)
Installation Wall mounting, pole mounting, corner mounting
Weight 1.2 kg (2.65 lb)
Note Optional external housing and mounting accessories may be required.
Intelligent Video Camera tamper
Video Motion Detection 3 independently configurable motion areas
Scheduling Daily repeat timing schedule
Imaging JPEG snapshots for pre/trigger/post alarm images
Video Recording Event/always recordings stored on the SD card
Custom Alarms HTTP event servers for setting customized alarm actions
Email/FTP Messaging Automatic transfer of stored images via email or FTP as event-triggered actions
Pre-alarm Buffer 50 MB video buffer for JPEG snapshot images
Password User level password protection
Filtering By IP address
Authentication 802.1X
Encryption HTTPS, SSH
Environmental Limits
Operating Temperature Standard model: -25 to 60°C (-13 to 140°F)
Wide Temp. model: -40 to 75°C (-40 to 167°F)
Storage Temperature -40 to 85°C (-40 to 185°F)
Ambient Relative Humidity 5 to 95% (non-condensing)
Vibration IEC 60068-2-6, 2 to 13.2 Hz: 2 mm (peak-peak); 13.2 to 100 Hz: 0.7g;
1.50 hrs/axis
IEC 60068-2-6, 3 to 9 Hz: 7 mm (peak-peak); 9 to 150 Hz: 1.0g;
1.86 hrs/axis
Shock IEC 60068-2-27, 20g/11ms
Altitude 2000 m
Standards and Certifications
Safety UL 60950-1
Rail Traffic EN 50121-4
EMC EN 55032/24
EMI CISPR 32, FCC Part 15B Class A
EMS IEC 61000-4-2 ESD: Contact: 6 kV; Air: 8 kV
IEC 61000-4-3 RS: 80 MHz to 1 GHz: 10 V/m
IEC 61000-4-4 EFT: Power: 2 kV; Signal: 2 kV
IEC 61000-4-5 Surge: Power: 2 kV; Signal: 2 kV
IEC 61000-4-6 CS: Signal: 10 V
IEC 61000-4-8
IEC 61000-4-11
Traffic Control NEMA TS2
Warranty Period 5 years (limited warranty on moving parts; see Moxa's online warranty policy for details)
Minimum Viewing System Requirements
CPU Intel Core i3 or above
Memory 2 GB of memory
OS Windows 7
Browser Internet Explorer 10 or above
Multimedia DirectX 11.0 or above
Software Development
VPort SDK PLUS Includes CGI commands, ActiveX Control, and API library for customized applications or system integration for third-party developers (the latest version of SDK is available for download from Moxa’s website).
Standard ONVIF Profile S